A Conductive Nylon Molding Trial
A marking concern on a PA6 component led to evaluation of carbon fiber reinforced PA66. The project account describes the customer comparing molded surfaces during a material trial.
Discuss Your ApplicationProject record
- Project requirement
- Evaluate surface appearance alongside electrical and flame requirements for a molded round component.
- What the processor observed
- The original PA6 part showed a visible mark under the customer’s informal fingernail check.
- What changed in the trial
- The customer trialed a 9200B-WFR PA66 formulation and repeated the same visual check.
- Results
- The customer reported no visible mark on the revised part in that check.
- Conditions and limits
- Several formulation variables changed together. The check is not a standardized scratch rating; the precise end use is unconfirmed.