Opens in a new tab
Contact
Black PA66 compound pellets
Side view of the pellet sample
Surface check on a molded sample
Conductive compound · PA66

9200B-WFR Carbon Fiber Conductive PA66

  • Reinforced PA66 — Black nylon 66 compound with 20% carbon fiber for molded parts requiring stiffness and electrical conductivity.
  • Injection molding — Supplied as pellets. Review drying and molding conditions before starting your production trial.
  • Electrical evaluation — Confirm the required resistivity range and measurement method, then check the finished part at agreed locations.
  • Flame performance — The grade data sheet lists V-0 at 3.0 mm. Confirm the requirement at your part’s minimum wall thickness.
Request the TDSDiscuss a trial

Technical data

Typical values from the ANSUYI grade data sheet.

Property Typical value Test method / condition
Electrical resistivity Request the range IEC 60093 · Ω·cm
Tensile strength 112.5 MPa ISO 527 · 5 mm/min
Flexural modulus 10,346.8 MPa ISO 178 · 2 mm/min
Flammability V-0 at 3.0 mm UL 94
Molding shrinkage 0.5–0.7% ISO 294-4
Density 1.367 g/cm³ ISO 1183 · 23 °C

Confirm the required flame classification at your part’s minimum wall thickness. Request the supporting test record for qualification.

Processing guide

Starting conditions for an injection molding trial.

Material drying
130 °C for 3–4 hours

Injection molding temperature
280–310 °C

Mold temperature
80–100 °C

Handheld meter used for a surface check

Handheld surface check on a molded specimen.

Application evaluation

Check conductivity on the molded part

Agree on the measurement locations, electrode arrangement and conditioning before sampling. A handheld surface reading and the TDS resistivity value in Ω·cm describe different measurements.

View the nylon molding trial

Processing questions

A surface mark appears on the molded component

PA66 · Injection molding
What to check

Repeat the observation under equivalent conditions. Record the resin, color and formulation changes separately from the electrical and flame acceptance tests.

Useful records

Comparison samples, inspection method and target wall thickness.

Grade information

Material profile
Carbon fiber reinforced conductive PA66 for injection molding trials. Supplied TDS: flexural modulus 10,346.8 MPa (ISO 178, 2 mm/min).
Processing guidance
Review surface marking on representative parts. Request the current flame report for your color and target thickness.
Request TDS

Trial 9200B-WFR in your mold

Share your drawing, minimum wall thickness, electrical target and sample quantity.

Before ordering
Ask for the current TDS revision, packaging, minimum order quantity, sample arrangements and dispatch availability for 9200B-WFR. Include your intended sample or production quantity so the reply can address your project.

Request a sample